Step flashing step flashing redirects the water back onto the shingle.
How to flash roof to wall.
Hammer one nail to the.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
Nail it in place with two nails one.
Above the roof sheathing.
Two ways to flash roof edges protect the eave from ice dams and sideways rain step one in steep slope roofing is the edge flashing.
All exterior wall coverings whether it is wood siding vinyl siding brick or stone veneer stucco etc.
Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge.
Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint.
There have always been problems with the flashing details at head walls rake walls and chimneys especially if stucco brick or stone veneer is used.
Roof to wall flashing.
Must be kept up off the surface of the roof a minimum 1 some manufacturers of exterior wall coverings require.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
One common method is to lay the edge metal under the eaves membrane and over the rake details concrete masonry roofing wrb flashing.
In this video isaac illustrates installation of an 18 w.
How to install roof flashing against a wall.
Flexible flashing tape seals the eave to the wall.
Most flashing is 8 inches wide.
Then set the piece down.
I cut the tape so that it laps onto the housewrap above and 3 in.
Bend it back so that it overlaps the corner flashing.
Iws is used in conjunction with step flashing or 4x5 wall flashing to create a water tight junction.
How to install step flashing with a wall corner step three.
