How To Hang A Curtain Rod On A Slanted Wall

They may have a pocket along the top to push the rod through or the rod may be threaded through eyelets or tabs.

How to hang a curtain rod on a slanted wall.

Draw the curtains and let them sit for 1 hour to make sure the adhesive hooks can hold the weight. If your curtain falls either the adhesive didn t fully stick to the wall or your curtain may be. I found these doodads called rod connectors or swivel socket on amazon to connect the rods at angled corners around 10 each. My curtains slide right over and if you get the same color as your rods they re pretty seamless looking.

You just have to make sure your rod size fits into the connector. The rest is pretty straightforward hammer in your anchors and secure your curtain rod hooks to the wall using the provided screws. Panel curtains eyelet curtains and tab top curtains are meant to hang from a plain round rod. Position the rod end.

Decide whether you want your curtain rod to hang on the window frame or extend past it. So using the correct drill bit size for your anchors is important. String your curtain on the curtain rod and hang it up. If your curtains have pleated drapery style headers hang them from a traversing rod with a one way draw.

A cord allows you to pull the drapes open and closed. Choose a rod that draws open away from the crowded end of the wall. I hate hanging curtain rods. It s easy to find a sliding curtain track system online or at your local hardware store.

Hang the curtain by the tabs from the slanted line of hooks or knobs at the ceiling shake it out to be sure it falls gracefully and then pull it back into gathers to reveal the window. Place the track on the sloped wall or where that wall meets the ceiling. Run the curtain rod through the hoops at the top of your curtains and then hang it up again. In most spaces a rod with decorative finials hung on the wall outside of the window frame will look best and provide the most coverage.

All that remained on the wall were two gaping holes in the plaster where screws apparently used to be. Use a sliding track such as the type of curtain tracks found in hospital rooms. It should be indicated in your curtain rod s instructions or on the box that your anchors came in. Mark the wall with a pencil to indicate this area.

To hang you must place drapery pins in the pleat and then hang them on the rod. I think this comes from when i was living in this super old house in san jose. Screw your hooks to the wall.