Step 1 measure the garage door opening before purchasing panels.
How to install a man door in a garage door.
Install a new 6 panel fiberglass door and hardware.
Use a tape measure to carefully record the length and width of the opening.
Finish the door as directed by the manufacturer.
Remove the door from the pre hung frame by removing the hinge pins.
For the headroom you should have about 10 to 12 of space depending on the spring system you re installing.
Center and level the first section after you install the brackets.
Apply paintable caulk and insulate around the entire door frame.
The door must be level even if the floor isn t so use shims under the section to level it.
Install latches door handles and other hardware.
Use the door shims if needed.
Next set the doorframe in the opening and center it in the opening.
Lay the panel flat on a workbench.
The rubber gasket on the bottom section will fill the gaps created by an unlevel floor.
At a home improvement store purchase some rubber weather stripping.
Use a drywall saw to cut shims or score them with a utility knife and snap them off.
Layout removal of drywall at new opening.
Order this size so the panels will be made slightly smaller fitting perfectly in the doorway.
Adjust the threshold for a tight seal as long as it is adjustable as directed by the manufacturer.
The panels will be about 1 4 in 6 4 mm smaller than the opening step 2 lay weather stripping over the bottom door panel.
Fill all nail holes with caulk and insulate with weather stripping where applicable.
Remove one screw from each of the hinges in the doorframe.
Replace them with 2 inch deck screws for strength.
Measure attach hinges and handles.
Sawcut and removal of a 3 wide section of the concrete kneewall to make it flush with the existing garage floor.
The stripping is shaped like.
To hold the level in place tape it to the section.
Drywall patching on interior.
Door opening height and width headroom from top of opening to ceiling and back room length of garage.