How To Install Shower Door Bottom Seal

The installation process will vary depending on whether you re installing a swinging or sliding glass door but either way you ll need to start by assembling a frame for the door.

How to install shower door bottom seal.

Ideally you will want to get the doors close to the halfway point on the guide so they are secure in it. Hold the shower guide above the bottom of the track as much as you can while you slide it onto the edges of the shower doors. Inspect the bottom of the shower door to determine the plastic seal attachment method. Position new sweep onto the bottom of the door.

Once the seal has been pressed into place continue working the remainder of the shower door seal onto the shower door by pressing it and sliding it onto the shower door. Mark how long it needs to be and use cutting pliers to cut to size. Snap the sweep onto the bottom of the door and slide into place. How to replace the plastic strip on a shower door.

Use just enough to touch both surfaces. Slide the shower doors back to one side and place the guide in the middle area of the shower track. Remove the metal drip rail if necessary for plastic seal access. Install the seal onto the door by pressing one end of the seal onto the corner or end of the door and then pushing the seal into place from this end working your way to the opposite end.

To install the shower door begin at one end of the shower door whether the bottom or the side of the shower door and slide the seal onto the shower door. Seals typically slide into a channel at the bottom of the. Staple from the center and work your way to both ends. How to replace a door sweep or bottom seal is one of the first video s where i did a voice over because the customer was a work a home lady who needed the.

Measure your new seal against the edge of your shower door. The seal should be tight and take some effort to get seated correctly. The staple on door bottom may seal better if a small spot of adhesive or caulk is applied to the bottom of the door before installing. One side of your bottom sweep will have a drip edge or lip that side is installed facing the inside of the shower.