How To Install Vinyl Connector Wall Panel

Turn off power at the circuit breaker before installing or cleaning the wall connector.

How to install vinyl connector wall panel.

Place the 22 1 2 571mm connector in the fi rst laid panel this can be inserted easily by hand and a light tap with the rubber mallet will ensure a ght connec on. Feed the loop through the knockout into the wall cavity. The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall. Gently remove any crown moulding baseboards and trim you plan on using again.

Then strip about two feet of sheathing off the end of the cable and cut off two of the three wires. This will allow it to adjust to the humidity in a room. Allow at least a 1 4 inch gap at floors and ceilings and at least 1 8 inch gap between the panels to allow for normal expansion. Install a corrugated roofing wall connector panel to a wall with roofing sealant when installing panels for a patio cover.

Make sure the first panel is plumb to the wall. Pull the bottom edge of the panel about 6 inches from the wall and push a block behind the sheet. Use a trowel and apply a 1 4 inch thick layer of frp adhesive to the back side of the first panel. The block we show here has a built in electrical box so you don t need the one in the wall.

Step 7 place two more spacers at the side of the wall and slide the second amdry panel into the connector of the fi rst panel. Insert the panel into the corner moulding. For best results set the paneling in the room for a few days before you install it. Do not install or use the wall connector near flammable explosive harsh or combustible materials chemicals or vapors.

This product can expose you to one or more chemicals that are known to the state of. If you use a block without an electrical box shift the existing electrical box out so you can mount the fixture to it. Drive four finishing nails through the top edge of the panel. Lay the panels on the ground the way you want them to be on the roof.

Position the panel on the wall leaving a 1 4 inch space at the bottom and drive the four nails partway into the wall. This helps in setting up the lap of the panels. Tape the end of the remaining wire to the end of the sheathing forming a loop. Start by removing a knockout in the box by hitting it with a screwdriver.