This can happen when the door has shifted to one side causing it to appear uneven.
How to level a garage door with side springs.
Step 3 check your cables.
So i thought the springs might be the next thing to conquer.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
Retest the door balance as you did in step 1.
It also depends a lot on the number of years the door has been up as it could be that the door springs have become.
Adjust the springs on both sides of the door the same way.
Thanks for your prompt response.
Kyle hogge ceo and founder at diy garage door parts will show you how to level a garage door from start to finish.
Is there a gap along the floor when it is closed.
There are several things that can cause this.
When this happens you need to shift it back into position.
With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder.
Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in.
Is the gap on one side only.
Once the spring is free of tension remove from its track hanger.
If it was opening too quickly move it to the next lower hole.
What is the door doing.
Especially when moving downward when closing the door the door moves from side to side.
Before attempting to adjust anything on your garage door you ll need to know exactly how big the gaps are that you re trying to close.
Too much tension on the springs.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
The most simple and common is door shift.
To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.
The most common cause of an uneven garage door is.
Adjusting an extension spring door.
The springs are not balanced and the side where the gap occurs needs to be adjusted.