Measure the length of the porch roof joint to determine how much flashing you will need.
Install flashing rood to awning.
Nail the upper edges of the flashing to the roof sheathing where the shingles were removed with 6 penny.
Place the flashing between the joint of the house and the roof.
If siding on.
Nail the flashing securely in place using roofing nails.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
Prepare the area where you will install the roof flashing.
After installing the brackets the installation process of the awning can vary based on the awning itself as well as the type of mounting.
Also take time to properly seal all edges of the mounting brackets with high quality silicone sealant.
Begin by removing the shingles at the affected area and removing old flashing if present.
If you already have faulty flashing installed you must remove it.
Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed.
How to install porch roof flashing.
A magnetic torpedo level will provide even mounting brackets and adequately adjusted roof brackets.
Position the flashing with the lower edges atop the carport roof panels along the transition.
Smart awnings with sensors.
Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z.
Try to keep the nails as flush as possible to the edges.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Less than a minute.
