We provide a fully licensed plumber to do all your gutter.
Installing gutter pops.
Use a square and pencil to mark the gutter length and cut to the line.
Secure it with eight pop rivets or sheet metal screws.
Slide the splices on as far as they ll go.
Here are the steps to installing a pop up gutter drain system.
Snap a chalk line between the start and end of the gutter run.
Snap the sections together.
It s much easier to join sections on the ground than to work from the top of a ladder.
Firmly hit the top of the nails with a hammer to drive them into each point.
Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section.
Begin by installing a slip joint splice on each end of an inside corner fitting.
Project step by step 20 cutting the gutter.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
Locate the endpoints and hold a nail over each.
How to install a pop up gutter drain.
Wrap the aluminum strip tight around the underside of the gutter.
These drains are attached to the end of a pipe that runs underneath the surface of your yard.