Installing Roof Rack Lights

It s a simple idea but basically you would route the wires up the driver side a pillar gut the manual roof antenna and replace it with a shark in style antenna.

Installing roof rack lights.

I have the lights mounting hardware and wiring harnesses but i am trying to figure out the best way to run the wiring from the rack to the engine bay and then into the. Once it is in the snorkel head the cable will run down into the dirty side of the airbox and will require drilling through the side of the airbox to penetrate the wiring back into the engine bay. This applies to any outback with a manual roof antenna or i suppose any vehicle for that matter. Plug the wiring harnesses into the lights.

Each roof rack light is different so installation could be according to each type. Roof rack lights installation. Push them into the rain gutter using a screen tool and run them under the wiper molding at the base of the windshield into the engine bay. I am planning to install 4 rigid dually spot lights on the front of my roof rack and 2 rigid dually flood lights on the back of my roof rack there are already mounting tabs.

Most manufacturers include installation guides to help put it up. Although not commonly adopted it is possible to loop the wire from a roof light bar into the back of the snorkel head. Zip tie them to the crossbars of your roof rack bringing one of the 12ga wires or to the driver side of the windshield and the other to the passenger side.